Chapter 1 Mathematics Tables, Blueprint Symbols, and Abbreviations
Objectives.
1.1 Introduction
1.2 The Metric System
1.3 Conversion Methods
1.4 Common Plumbing Abbreviations
1.5 Common Plumbing Symbols
1.6 Common Electrical Symbols and Abbreviations
1.7 Common HVAC symbols and Abbreviations
Summary
Assignment 1.1 through 1.5
Chapter 2- Tools of the Trade
Objectives
2.1 Introduction
2.2 Architecture and Engineer Scale Rulers
2.3 Metric Scale Ruler
2.4 Slide Square
2.5 Isometric Drafting Triangle
2.6 Drafting Templates
Summary
Assignment 2.1 through 2.5
Chapter 3-Offset and Capacity Formulas
Objectives
3.1 Introduction
3.2 Right Triangle Basics
3.3 45-Degree Piping Offsets
3.4 22 1/2-Degree Piping offsets
3.5 Cylindrical Tank Capacity
3.6 Trench Volume
Summary
Assignment 3.1 through 3.9
Chapter 4-Architectural Blueprint Reading
Objectives.
4.1 Introduction
4.2 Reflected Ceiling Plan
4.3 Corridor Coordination
4.4 The Piping Layout
4.5 The Core Plan
Summary
Assignment 4.1 through 4.6
|
Chapter 5-Isometric Introduction: Various View Comparisons
Objectives
5.1 Introduction
Summary
Assignment 5.1 through 5.11
Chapter 6-Fabrication Details: Design Intent
Objectives
6.1 Introduction
6.2 Architectural Design Intent
6.3 As-Built Installation Design
6.4 Shop Drawings
Summary
Assignment 6.1 through 6.5
Chapter 7-Riser Diagrams
Objectives
7.1 Introduction
7.2 Drainage Waste and Vent
Summary
Assignment 7.1 through 7.5
Chapter 8-Lesson Overview: Drafting Practice
Objectives
8.1 Introduction
Practice Format One
Practice Format Two
Practice Format Three
Practice Format Four
Practice Format Five
Practice Format Six
Practice Format Seven
Practice Format Eight
Summary
Assignment 8.1 through 8.4
Index |
