CHAPTER 1: TABLES FOR PLUMBING
Pipe Tables (and Conversion factors)
Conversion Tables (Inches to Decimal Feet)
Decimal to Fraction Conversions
Common Premium Backfill Yields
1/16", 1/8", 1/4", and 1/2" Fall Conversion Tables
CHAPTER 2: UNDERGROUND ROUGH IN ILLUSTRATIONS
Grade, Fall & Slope Illustrations
Grade, Fall & Slope Calculations
Rise from Main Sewer
Leveling
Center Main Rough-ln
CHAPTER 3: SIZING
Backfill for Trenches
Roof Drains
Oil Interceptors
CHAPTER 4: LAYOUT ILLUSTRATIONS
Trench Layout for 22.5°, 45°, 60° and 90°
Calculating a 22.5° Roll
Calculating a 45° Roll
Calculating a 60° Roll
CHAPTER 5: PVC SCH. 40 OFFSETS
22.5°, 45°, 60° Offsets
90° Elbow Rolled at a 22.5°, 45°, 60°
One-Piece Combination at 22.5°, 45°, 60° Roll
Four-Piece Double T-Wye
|
CHAPTER 6: NO HUB CAST IRON OFFSETS
22.5° , 45°, 60° Offsets
1/4 Bend rolled at a 22.5°, 45°, 60°.
One-Piece Combination at 22.5°, 45°, 60° roll
Four-Piece Double T-Wye
CHAPTER 7: SV. CAST IRON OFFSETS
22.5°, 45°, 60° Offsets
1/4 Bend Rolled at 22.5°, 45°, 60°
One-Piece Combination Rolled 22.5°,45°, 60°
4-Piece D
CHAPTER 8: COMMON PLUMBING ILLUSTRATIONS
Air Gap, Air Break, Branch
Building Sub-drain, Sewage Ejector
Common Vent, Combination Waste and Vent
Circuit Vent
Relief Vent, Stack Vent,
Yoke Vent, Vent Stack, Stack Vent, Water Seal, Individual Vent
Stack Venting
Individual Vent within a Circuit Vent
Wet Venting
Common Venting
Isometric Sketch Pad
|
