Rated to 1000 lbs
I really like this tool with pipe above 12". especially if you are in a valve pit or on a high line. You can level the face of elbows, tees, and (flanges too when used along with the S113 Adjust-a-Flange with this tool. It really makes the work much safer than trying to hand hold heavy fittings.

S113 Adjust-a-Flange sold separately.

Rated to 1000lbs
This Sumner tool will allow you to pick up a pretty heavy flange and it will be automatically two holed.
If you use it with the S113 Adjust-a-Fit, it will level the face of the two-holed flange too. This combination makes working with heavy fittings and flanges a lot safer.

Easy to read digital gauge
Spring-loaded striking pin
Magnetic base
Removable gage with magnetic base
Comes in metal carrying case
Guaranteed to work for 1″—4″ pipe

Time saving aligner
Two hole the flange and squares it to the pipe all in one go
Uses Quik Pin system
Easily replaceable vials
Automatically centers ⅝″ to 1⅝″ holes

Works for flanges up to 3⅝″ thick and has a shaft length of 5⅝″.

Check our Two Hole Pin Chart to find the Two Hole Pins that meet your needs.

A quick, easy, and safe hold down clamp for pipe in Vee Head Stands
Grips 3/4″ pipe to 6″ pipe.
Quick release button for quick, easy clamping and release.

Line up your pipe and fitting from the inside. This internal clamp will even out the hi-lo.  Pipe Sizes: 2″ to 4″. It is not made to hold the heavier pipe and fitting up though.
This is a well designed internal pipe clamp with a lifetime warranty on the body. Every welder will appreciate the ability to make a good root pass wil even walls.

This setup makes sense. Pipe fitters use two framing squares to check various fits at 90° angles. Two 45° squares allows you to check an even wider range of fits. The locking device to hold them together and in alignment in six different configuration is smart. Mul-t-square is made by Sumner Mfg. The squares are marked in Inches and Metric.

Quick installing pins work as convenient reference points to level flange for tack and weld-out —no tools needed
Hardened tapered Qwik Pins automatically center on ⅝″ to 1⅝″ (16 to 42 mm) holes
Features acme threads for maximum clamping power and hardened steel for long lasting use. These are a fine pair of two hole pins to have in your tool box.

Check our Two Hole Pin Chart to find the Two Hole Pins that meet your needs.

2 hole flange pins.
A quarter is shown beside the two hole pins for scale
Pins automatically center on ⅝″ to 1⅝″ (16 to 42 mm) holes

Check our Two Hole Pin Chart to find the Two Hole Pins that meet your needs.

Push button "Qwik" system
Smooth Clamping for positive gripping
Stainless Steel contacts and screws
Operating handle for fine tuning
Light weight for overhead work

Push button design allows for rapid action setting and fine tune thread adjustment
Rugged frame, built for job site use
Smooth roller clamping action for positive gripping
Stainless steel contacts & alignment screws
Operating handle repositions for close work
Fine adjustment screws for quick fit-up
Light weight for overhead work

Push button "Qwik" system
Smooth Clamping for positive gripping
Stainless Steel contacts and screws
Operating handle for fine tuning
Light weight for overhead work