#33 Universal Level-Two hole pins fit between 2 1/4” to 8” centers on flanges.
The Curv-O-Mark® Universal Level is a multi-purpose tool. The unit features a 360° adjustable protractor dial bubble (DSL) that ensures accurate leveling and permits the following additional uses:
° Setting a predetermined pitch of a string of pipe
° Setting the angle of laterals to a precise degree
° Trueing vertical runs
° Two-holing flanges
The Level has two cast-in 25-pound magnets (exerting a 50-pound pull) to securely hold the unit in place on any steel surface, including the underside of a pipe or beam. This permits hands-free leveling, a welcome aid in tight spots. And, since the bubble is mounted on a protractor dial, the Level may be used in any position and still read accurately. While one face of the Level is magnetic, both faces have deep, cast-in grooves that make the Level self-centering on the contour of the pipe. Because the magnets are cast in, they do not interfere with the use of the Level on non magnetic materials, such as aluminum, copper, lumber, stone or other materials requiring leveling.
For aligning pipe flanges (two-holing), the Level comes with a two-threaded, self aligning conical spacer and conical nut and bolt units. These are designed to fit any size bolt hole spaced between 2-1/4 in. to 8-in. centers on flanges. This permits the orientation of flange bolt holes for any size pipe.
Designed primarily for pipefitting applications, the Universal Level is a valuable tool for any craft required to use a level or a plumb bob:
° For structural ironworkers, the powerful holding magnets provide an extra hand
° Electricians will find the Level useful in laying out and lining up heavy conduit
° With the aid of a handy conversion chart, carpenters can use the Level for the layout of roof rafters
A built-in adjustable dial bubble protractor ensures accurate centerline location. A cast-in table indicates rise per foot in both inches and meters. A cast-in grooves makes the level self centering on the contour of pipe.
Two-holing is simplified with the Universal Level. Self-aligning spacer bolt units are attached in the two adjacent bolt holes at the top or bottom of the flange With the DSL dial set at O degrees, the flange is rotated until the bubble is centered.
If adjacent top or bottom holes cannot be used, two-holing can be achieved using side bolt holes. In this instance, the DSL dial is set at 90 degrees and the flange is rotated until bubble is centered.
Bolt holes that are offset can be matched by setting the DSL at the desired offset angle prior to rotating the flange.